2 | User information STOBER
8
12/2018 | ID 442537.05
2 User information
This documentation covers the SD6 drive controller. You will receive support for the assembly of
the individual modules along with the associated components that you will need to operate the
drive controllers in the control cabinet.
You will also find information on wiring the modules correctly and checking their functionality in
the group with an initial test.
More information on project configuration and diagnostics can be found in the manual for the
SD6 drive controller; see the chapter Detailed information [}161].
Information
To ensure proper functionality, we recommend using cables from STOBER that are matched to
the complete system. In case of use of unsuitable connection cables, we reserve the right to
reject claims under the warranty.
2.1 Storage and transfer
As this documentation contains important information for handling the product safely and
efficiently, it must be stored in the immediate vicinity of the product until product disposal and be
accessible to qualified personnel at all times.
Also pass on this documentation if the product is transferred or sold to a third party.
2.2 Described product type
This documentation is binding for:
SD6 drive controllers in conjunction with the
DriveControlSuite software V 6.3-E or higher, PASmotion V 1.3.0 or higher and associated
firmware V 6.3-E or higher.
2.3 Timeliness
Check whether this document is the most up-to-date version of the documentation. We provide
the latest document versions for our products for download on our website: http://
www.stoeber.de/en/download.
2.4 Original language
The original language of this documentation is German; all other language versions are derived
from the original language.
2.5 Limitation of liability
This documentation was created taking into account the applicable standards and regulations
as well as the current state of technology.
STOBER shall assume no responsibility for damage resulting from failure to comply with the
documentation or from use that deviates from the intended use of the product. This is especially
true for damage caused by individual technical modifications to the product or projecting and
operation of the product by unqualified personnel.
To Next Page
Loading...
Need help?
General
