Subaru FORESTER 2012 - Page 141

Black plate (146,1)
一般Model "A8170GE-A" EDITED: 2011/ 7/ 3
3-28 Instruments and controls
! List of warnings
S03AE5504
Inside warning
chime
Outside warning
chime
Access key
warning light on
meter
Operation indi-
cator on push-
button ignition
switch
Status Action
Ding,
ding ...
(intermittent)
———
The driver’s door was opened while
the push-button ignition switch is
“Acc” (in AT models, when the
select lever is in the “P” position).
Switch the push-button ignition
switch to “OFF”, or close the driver’s
door.
*When exiting the vehicle, be sure
to switch the push-button ignition
switch to “OFF”.
The push-button ignition switch was
switched to “OFF” while the driver’s
door is open.
Close the driver’s door.
—
Short beep
(2 seconds)
——
An attempt was made to lock all
doors while the access key is left
inside the vehicle.
Take out the access key from the
vehicle, and lock the doors.
*The doors cannot be locked while
the access key is inside the vehicle.
*A chirp sound will be heard, and all
doors will be unlocked.
The door lock button was pressed
while the push-button ignition
switch is “OFF” and the access key
is inside the vehicle.
Take out the access key from the
vehicle, and lock the doors.
*If the access key is inside the
vehicle, the doors cannot be locked.
—
Beep
(10 seconds)
——
The door lock/“
” button is pushed
while the push-button ignition
switch is in the “OFF” position and
one of the doors including the rear
gate is opened.
Close the doors securely and lock
them.
*If one of the doors including the
rear gate is opened, the doors
cannot be locked.
—
Long beep (60
seconds max.)
——
The door lock/“
” button was
pressed while carrying the access
key and the push-button ignition
switch is in a position other than
“OFF” (in AT models, when the
select lever is in the “P” position).
Return the access key to the inside
of the vehicle, or switch the push-
button ignition switch to “OFF”.
*If the push-button ignition switch is
not switched to “OFF”, the doors
cannot be locked.