Black plate (100,1)
一般Model "A8170GE-A" EDITED: 2011/ 7/ 3
2-12 Keys and doors
locking the doors and rear gate. It is not
possible to lock the doors and rear
gate using the door lock button, rear
lock button or access key button when
the push-button ignition switch is in the
“Acc” or “ON” position. Refer to
“
s03bg02Switching power” F3-6.
. Locking by the door lock button can
be operated only by the door lock
button in the operating range in which
the access key is detected.
. Unlocking by the door handle can be
operated only by the door handle in the
operating range in which the access
key is detected.
. Locking and unlocking by the door
lock button and the door handle cannot
be operated for a short period of time
(approximately les s than 1 second)
after locking or unlocking to prevent
malfunctions.
. When pressing the door lock button
too quickly, locking may not have been
completed. After locking the doors, it is
recommended to pull the REAR door
handles to confirm that the doors have
been locked.
. If the access key is placed too close
to the vehicle body, the keyless access
functions may not operate properly. If
they do not operate properly, restart
the operation from further away.
. If the access key is placed near the
ground or in an elevated location from
the ground, even if it is in the indicated
operating range, the keyless access
functions may not operate properly.
. When the access key is within the
operating range, it is possible for any-
one, even someone who is not carrying
the access key, to operate the keyless
access function. Note that locking and
unlocking can be operated only by the
door handle, door lock button, rear
gate opener button or rear lock button
in the operating range in which the
access key is detected.
. The keyless access functions may
not operate properly depending on the
status of the access key and the radio
wave conditions around the vehicle. In
such a case, perform the procedure
described in “
s09ap01Locking and unlock-
ing” F9-16.
. It is not possible to lock the doors
and rear gate using the keyless access
function when the access key is inside
the vehicle. However, depending on the
status of the access key and the
environmental conditions, the access
key may be locked inside the vehicle.
Before locking, make sure that you
have the access key.
. When the battery of the access key
is discharged, or when operating it in a
location with strong radio waves or
noise (e.g., near a radio tower, power
plant, broadcast station or an area
where wireless equipment is used), or
while talking on a cell phone, the
operating ranges may be reduced, or
the keyless access functions may not
operate.
In such a case, perform the procedure
described in “
s09ap01Locking and unlock-
ing” F9-16.
. It is not possible to lock the doors
when one of the doors is open. Close
all of the doors including the rear gate
and lock the doors.
. When an access key is in the
operating range, if the door handle
becomes wet due to a large amount of
water while washing the vehicle or
during heavy rain, the door lock may
be released.
. If the door handle is gripped with a
gloved hand, the door lock may not be
released.
! How to use keyless access func-
tions
S02AP0102
NOTE
. Within 3 seconds after locking the
doors and the rear gate by pressing the
door lock button or the rear lock
button, it is not possible to unlock the
doors and/or the rear gate by gripping
To Next Page
Loading...
