Supermicro SSE-F3548S - 3.14 Private Edge VLAN;Protected Ports

Supermicro SSE-F3548S/SSE-F3548SR Configuration User’s Guide
113
Hybrid Forbidden Ports: None
Access Ports: None
Trunk Ports: fx 0/1-10 po 1
Name:
Status: Permanent
----------------------------------------------------
Vlan ID: 30
Member Ports: fx 0/1-10 po 1
Hybrid Tagged Ports: None
Hybrid Untagged Ports: None
Hybrid Forbidden Ports: None
Access Ports: None
Trunk Ports: fx 0/1-10 po 1
Name:
Status: Permanent
----------------------------------------------------
SMIS#
3.14 Private Edge VLAN/Protected Ports
The private edge VLAN (also called the Protected Ports feature) helps to isolate traffic among the same
VLAN ports. A protected port cannot forward any traffic to another protected port on the switch even if
they are in the same VLAN.
Switch ports can be configured to operate in one of the following three modes.
3.14.1 Unprotected Port
By default all the ports in the switch are unprotected ports. Unprotected ports can send and receive traffic
with all the other ports including other unprotected, protected and community ports based on the VLAN
membership.
3.14.2 Protected Port
Protected ports can send and receive traffic only with unprotected ports in the same VLAN. A protected
port cannot send or receive traffic with other protected ports or community ports. Protected ports are also
called isolated ports.
3.14.3 Community Port
Community ports can send and receive traffic with unprotected ports and other ports in the same
community.
Port Mode
Communicates with
Unprotected Ports
Unprotected Ports