Supermicro SSE-F3548S - Immediate Leave

Supermicro SSE-F3548S/SSE-F3548SR Configuration User’s Guide
200
message retry count.
count – may be any value from 1 to 5
seconds. The default is 2.
Step 3
end
Exits the configuration mode.
Step 4
show ip igmp snooping globals
Displays the IGMP snooping group
specific query message retry count
information.
Step 5
write startup-config
Optional step – saves this IGMP
snooping configuration to be part of
the startup configuration.
The “no ip igmp snooping retry-count” command resets the group specific query retry count
value to its default value of 2.
The example below shows the commands used to configure the retry count for group specific query
messages.
Configure the group specific query message retry count as 3.
SMIS# configure terminal
SMIS(config)# ip igmp snooping retry-count 3
SMIS(config)# end
7.5.3 Immediate Leave
The switch can be configured to immediately remove a port from the group entry on the multicast table if
it receives an IGMP leave message without sending out group specific query messages. This function is
called immediate leave and it is configurable per a VLAN basis. Immediate leave is disabled by default in
all VLANs.
Follow the steps below to enable the immediate leave for any VLAN.
Step
Command
Description
Step 1
configure terminal
Enters the configuration mode.
Step 2
vlan<vlan-list>
Enters the VLAN configuration mode.
vlan-list – may be any VLAN number or
list of VLAN numbers. Multiple VLAN
numbers can be provided as comma-
separated values. Consecutive VLAN
numbers can be provided as a range,
such as 5-10.
If multiple VLANs are provided, the next