Supermicro SSE-F3548S - System MTU

Supermicro SSE-F3548S/SSE-F3548SR Configuration User’s Guide
48
System Contact: http://www.supermicro.com
System Location: Santa Clara
Logging Option: Console Logging
Login Authentication Mode: Local
Snoop Forward Mode: MAC based
Config Restore Status: Not Initiated
Config Restore Option: No restore
Config Restore Filename: iss.conf
Config Save IP Address: 0.0.0.0
Device Up Time: 0 days 0 hrs 51 mins 39 secs
Boot-up Flash Area: Normal
NTP Broadcast Mode: No
[NTP] ntp is disabled
Server Key Prefer
=============== ===== ======
Key # Key
======= ====================================
Time zone offset not set
2.5.4 System MTU
The default maximum transmission unit (MTU) size for frames received and transmitted on all interfaces of
the switch is 1500 bytes. The MTU size can be increased for all interfaces of the switch at the same time by
using the ‘system MTU’ command.
Follow the steps below to configure the system MTU.
Step
Command
Description
Step 1
configure terminal
Enters the configuration mode
Step 2
system mtu <frame-size(1500-9216)>
Configure System MTU.
frame-size – Specify MTU of frame in
range 1500-9216.
Step 3
End
Exits the configuration mode.
Step 4
show interface mtu
Displays the interface MTU.
Step 5
write startup-config
Optional step – saves this configuration
to be part of startup configuration.
The “no system mtu” command resets the system MTU to its default value of 1500 bytes.
The example below shows the commands used to configure the system MTU.
SMIS# configure terminal
SMIS(config)# system mtu 9200