Supermicro SSE-F3548S - Group

Supermicro SSE-F3548S/SSE-F3548SR Configuration User’s Guide
288
Authentication Protocol: MD5
Privacy Protocol: DES_CBC
Storage Type: Volatile
Row Status: Active
------------------------------
Engine ID: 80.00.08.1c.04.46.53
User: initial
Authentication Protocol: None
Privacy Protocol: None
Storage Type: Volatile
Row Status: Active
------------------------------
Engine ID: 80.00.08.1c.04.46.53
User: templateMD5
Authentication Protocol: MD5
Privacy Protocol: None
Storage Type: Volatile
Row Status: Active
------------------------------
Engine ID: 80.00.08.1c.04.46.53
User: templateSHA
Authentication Protocol: SHA
Privacy Protocol: DES_CBC
Storage Type: Volatile
Row Status: Active
------------------------------
11.6.4 Group
A group identifies a set of users in SNMPv3.
Follow the steps below to configure an SNMP group.
Step
Command
Description
Step 1
configure terminal
Enters the configuration mode
Step 2
snmp group <GroupName> user <UserName>
security-
model {v1 | v2c | v3 } [{volatile |
nonvolatile}]
Configures the SNMP group.
GroupName – Alphanumeric value with
a maximum of 40 characters.
Security-model – Use v1 or v2c or v3.
UserName - Alphanumeric value with a
maximum of 40 characters.
Use volatileif the value need not be
stored in NVRAM.
Use nonvolatile if the value must be