Supermicro SSE-F3548S - Console Log; Log File

Supermicro SSE-F3548S/SSE-F3548SR Configuration User’s Guide
56
Buffered size: 50 Entries
LogBuffer: (0 Entries)
LogFile: (0 Entries)
2.6.3 Console Log
System logging messages can be displayed in switch console.
Follow the steps below to enable the Syslog console.
Step
Command
Description
Step 1
configure terminal
Enters the configuration mode
Step 2
logging console
Enable Syslog Console.
Step 3
End
Exits the configuration mode.
Step 4
show logging
Displays the Syslog configuration.
Step 5
write startup-config
Optional step – saves this configuration
to be part of startup configuration.
The “no logging console” command disables console logging.
The example below shows the commands used to enable Syslog console.
SMIS# configure terminal
SMIS(config)# logging console
SMIS(config)# end
SMIS# show logging
System Log Information
----------------------
Syslog logging: enabled(Number of messages 0)
Console logging: enabled(Number of messages 0)
File logging: disabled(Number of messages 0)
Log File Name:
File Max Entries: 500
TimeStamp option: enabled
Trap logging: Critical
Log server IP: None
Facility: Default (local0)
Buffered size: 50 Entries
LogBuffer: (0 Entries)
LogFile: (0 Entries)
2.6.4 Log File
System logging messages can be stored as a log file in the switch NVRAM.