Supermicro SSE-F3548S - Group Access

Supermicro SSE-F3548S/SSE-F3548SR Configuration User’s Guide
291
Step 5
write startup-config
Optional step – saves this SNMP
configuration to be part of the startup
configuration.
The “no snmp view <ViewName><OIDTree> ”command deletes the specified SNMP view.
The example below shows the commands used to configure the SNMP view.
SMIS(config)# snmp view view1 1.3.6.1 included
SMIS(config)# show snmpviewtree
View Name: iso
Subtree OID: 1
Subtree Mask: 1
View Type: Included
Storage Type: Non-volatile
Row Status: Active
------------------------------
View Name: view1
Subtree OID: 1.3.6.1
Subtree Mask: 1.1.1.1
View Type: Included
Storage Type: Volatile
Row Status: Active
------------------------------
View Name: Restricted
Subtree OID: 1
Subtree Mask: 1
View Type: Excluded
Storage Type: Non-volatile
Row Status: Active
------------------------------
11.6.6 Group Access
Group access defines the access policy for a set of users belonging to a particular group. Group access is
used only for SNMPv3.
Follow the steps below to configure SNMP group access.
Step
Command
Description
Step 1
configure terminal
Enters the configuration mode
Step 2
snmp access <GroupName> {v1 | v2c | v3 {auth |
noauth | priv}}[read <ReadView | none>] [write
<WriteView | none>] [notify <NotifyView | none>]
Configures the SNMP group access.
GroupName - Alphanumeric value with