Supermicro SSE-F3548S - Static Router Ports

Supermicro SSE-F3548S/SSE-F3548SR Configuration User’s Guide
197
SMIS(config)# ip igmp snooping mrouter-time-out 90
SMIS(config)# end
7.4.2 Static Router Ports
Router ports can also be configured statically. Router ports are configured per VLAN basis.
Follow the steps below to configure the static router portfor any VLAN.
Step
Command
Description
Step 1
configure terminal
Enters the configuration mode.
Step 2
vlan<vlan-list>
Enters the VLAN configuration mode.
vlan-list – may be any VLAN number or
list of VLAN numbers. Multiple VLAN
numbers can be provided as comma-
separated values. Consecutive VLAN
numbers can be provided as a range,
such as 5-10.
If multiple VLANs are provided, the next
step will configurethe router ports for
all these VLANs.
Step 3
ip igmp snooping mrouter<interface-
type><interface-id>
Configures the router port.
interface-type – may be any of the
following:
fx-ethernet – fx
cx-ethernet – cx
portchannel – po
interface-id is in slot/port format for all
physical interfaces. It may be the port
channel identifier for port channel
interfaces.
Step 5
end
Exits the configuration mode.
Step 6
show ip igmp snooping mrouter [vlan<vlan>]
Displays the IGMP snooping router port
information. If a VLAN identifier is
provided it displays the router port for
the given VLAN. If a VLAN identifier is
not provided it displays the router
portsfor all the VLANs on the switch.
Step 7
write startup-config
Optional step – saves this IGMP
snooping configuration to be part of
the startup configuration.