Supermicro SSE-F3548S - Switch Name

Supermicro SSE-F3548S/SSE-F3548SR Configuration User’s Guide
45
2.5.1 Switch Name
Supermicro switches can be assigned a name for identification purpose. The default switch name is SMIS.
The switch name is also used as a prompt.
Follow the steps below to configure the Switch Name.
Step
Command
Description
Step 1
configure terminal
Enters the configuration mode
Step 2
device name <devname(15)>
Configure Switch Name and prompt.
Devname– Switch name specified as 1-
15 alphanumeric characters.
Step 3
End
Exits the configuration mode.
Step 4
show system information
Displays the system information
configuration.
The device name configuration is automatically stored as part of startup-config file.
The example below shows the commands used to configure the switch name.
SMIS# configure terminal
SMIS(config)# device name switch1
switch1(config)# end
switch1# show system information
Switch Name: switch1
Switch Base MAC Address: 00:30:48:e3:70:bc
SNMP EngineID: 80.00.08.1c.04.46.53
System Contact: http://www.supermicro.com/support
System Location: Supermicro
Logging Option: Console Logging
Login Authentication Mode: Local
Snoop Forward Mode: MAC based
Config Restore Status: Not Initiated
Config Restore Option: No restore
Config Restore Filename: iss.conf
Config Save IP Address: 0.0.0.0
Device Up Time: 0 days 0 hrs 1 mins 11 secs
Boot-up Flash Area: Normal
NTP Broadcast Mode: No
[NTP] ntp is disabled
Server Key Prefer