Supermicro SSE-F3548S - 12.2 RMON Configuration

Supermicro SSE-F3548S/SSE-F3548SR Configuration User’s Guide
315
12.1.2 Event Group
The event group defines event indexes and controls the generation and notifications of the events
triggered by the alarms defined in the alarm group. The events can be handled by either of the following
ways:
• Logging event related information in the event log table of the RMON MIB of the switch.
• Trap: Sending a trap to notify the occurrence of this event to the management device.
12.1.3 Statistics
RMON statistics function is implemented by either the Ethernet statistics group or the history group. The
objects of the statistics are different for both these groups;however both groups record statistics on the
interfaceas a cumulative sum for a particular period.
12.1.3.1 History group
The history group specifies periodic collection of traffic information statistics on an interface and saves
the statistics in the history record table. The statistics data includes bandwidth utilization, number of
error packets, and total number of packets.
12.1.3.2 Ethernet statistics group
The statistics group specifies collection of various traffic statistics information on an Ethernet interface
and saves it in the Ethernet statistics table. The statistics data includes network collisions, CRC alignment
errors, undersize/oversize packets, broadcasts, multicasts, bytes received, and packets received etc.
12.2 RMON Configuration
This section describes RMON configuration for Supermicro switches.
Parameter
Default Value
RMON status
Disabled
Collection statistics
None
Collection history
None
Alarms
None
Events
None
12.2.1 EnablingRMON
RMON is disabled by default in Supermicro switches. Follow the below steps to enable RMON.
Step
Command
Description
Step 1
configure terminal
Enters the configuration mode
Step 2
set rmon enable
Enable RMON in the switch.
Step 3
End
Exit from Configuration mode.
Step 4
Show rmon
Display RMON status.