Supermicro SSE-F3548S - 9.7 Configuring CoS-Based QoS

Supermicro SSE-F3548S/SSE-F3548SR Configuration User’s Guide
265
setqos enable
class-map 1
match access-group ip-access-list 1
exit
policy-map 1
class 1
police 500000 exceed-action policed-dscp-transmit 10
exit
exit
9.7 Configuring CoS-Based QoS
Follow the steps below to configure CoS-Based features such as default priority, scheduling and
bandwidth.
Step
Command
Description
Step 1
configure terminal
Enters the configuration mode
Step 2
vlan map-priority <priority value(0-7)> traffic-class
<Traffic class value(0-7)>
Maps a priority to a traffic class in the
switch. The frame received with the
configured priority will be processed in
the configured traffic class.
Priority- Priority of the packet, in range
of 0-7.
Class –Traffic class in range of 0-7.
Step 3
interface <interface-type><interface-id>
or
interface range <interface-type><interface-id> ….
(Optional) Enters the interface
configuration mode.
interface-type – may be any of the
following:
fx-ethernet – fx
cx-ethernet – cx
interface-id is in slot/port format for all
physical interfaces.
To configure multiple interfaces, use
the “interface range …” command. To
provide a range use a hyphen (-)
between the start and end interface