Supermicro SSE-F3548S - LACP Parameters

Supermicro SSE-F3548S/SSE-F3548SR Configuration User’s Guide
131
…” command. To provide a range, use a
hyphen (-) between the start and end
interface numbers.
E.g.: no int range po 1-3
To provide multiple interfaces or
ranges, separate with a comma (,).
E.g. : no int range po 1, 2
Step 3
show running-config
Displays the port channel information.
show etherchannel
Step 4
write startup-config
Optional step – saves this port channel
configuration to be part of startup
configuration.
When a port channel is removed, all its member ports will be automatically added to VLAN 1.
The MTU and spanning tree configurations of that port will not automatically be changed to
their default configurations.
The example below shows the necessary steps to remove a port channel interface.
Remove port channel 10 and add all its member ports to VLAN 10 as access ports.
SMIS# configure terminal
SMIS(config)# no int port-channel 10
SMIS(config)# interface range cx 0/1-2
SMIS(config-if)# switchport mode access
SMIS(config-if)# switchport access vlan 10
SMIS(config-if)# exit
4.6.4 LACP Parameters
Users can configure the following LACP parameters on Supermicro switches.