Supermicro SSE-F3548S - Displaying MAC Extended Acls

Supermicro SSE-F3548S/SSE-F3548SR Configuration User’s Guide
226
that needs to be removed from this
interface.
access-list-name – the name of the ACL
which needs to be removed from this
interface.
Step 4
show access-lists
Displays the configured ACL rules to
make sure this port is removed from
required ACL.
Step 5
write startup-config
Optional step – Saves this ACL
configuration to be part of startup
configuration.
1. When a MAC Extended ACL is removed from the egress port it was applied to, that
ACL will become a switch-wide ACL (applied to all physical ports).
2. MAC Extended ACLs can be configured with only physical egress ports like fx or cx
ports. They cannot be configured with port channel interfaces.
The example below shows the commands used for removing a MAC Extended ACL from a port.
SMIS# configure terminal
SMIS(config)# int fx 0/1
SMIS(config-if)# no mac access-group 100 in
8.2.7 Displaying MAC Extended ACLs
Step
Command
Description
Step 1
show access-lists
or
show access-lists mac{ <access-list-number (1-
32768)> | <access-list-name> ]
Enters the configuration mode
access-list-number – the ACL number
that needs to be displayed
access-list-name – the name of the ACL
which needs to be displayed
The show command displays the following information for every MAC Extended ACL:
Filter Priority
ACL’s configured or default priority
Protocol Type
Configured protocol. If not configured, it shall be displayed as zero.
Vlan Id
Configured VLAN identifier.
Destination MAC
Address
Configured destination host MAC address. Displays 00:00:00:00:00:00
for any destination MAC address
Source MAC Address
Configured source host MAC address. Displays 00:00:00:00:00:00 for
any source MAC address