Supermicro SSE-F3548S - 11.7 Trap

Supermicro SSE-F3548S/SSE-F3548SR Configuration User’s Guide
294
Read View: iso
Write View: iso
Notify View: iso
Storage Type: Non-volatile
Row Status: Active
------------------------------
11.7 Trap
11.7.1 Target Address
A target is a receiver of SNMP notification(s), which are usually SNMP Managers. The target address
defines the transport parameters of the receivers.
Follow the steps below to configure the SNMP Target address.
Step
Command
Description
Step 1
configure terminal
Enters the configuration mode
Step 2
snmptargetaddr<TargetAddressName>param<ParamName>
{<IPAddress> | <IP6Address>} [timeout <Seconds(1-1500)]
[retries <RetryCount(1-3)] [taglist<TagIdentifier | none>]
[{volatile | nonvolatile}]
Configures the SNMP target
address information.
TargetAddressName -
Alphanumeric value with a
maximum of 40 characters.
ParamName – The parameter
to be notified to the specific
target. Alphanumeric value with
a maximum of 40 characters.
IPAddress– IPv4 address of the
target.
IP6Address – IPv6 address of
the target.
Seconds – Specifies the timeout
within which the target should
be reachable.
RetryCount – Specifies the
number of retries to reach the
target.
TagIdentifier- A set of targets
can be grouped under a tag
Identifier.