Supermicro SSE-F3548S - Page 293

Supermicro SSE-F3548S/SSE-F3548SR Configuration User’s Guide
293
3. Delete the group.
The example below shows the commands used to configure the SNMP group access.
SMIS# configure terminal
SMIS(config)# snmp access group5 v3 auth read view1 write view2 notify none nonvolatile
SMIS(config)# end
SMIS# show snmp group access
Group Name: iso
Read View: iso
Write View: iso
Notify View: iso
Storage Type: Volatile
Row Status: Active
------------------------------
Group Name: iso
Read View: iso
Write View: iso
Notify View: iso
Storage Type: Volatile
Row Status: Active
------------------------------
Group Name: group5
Read View: view1
Write View: view2
Notify View:
Storage Type: Non-volatile
Row Status: Active
------------------------------
Group Name: Initial
Read View: Restricted
Write View: Rrestricted
Notify View: Restricted
Storage Type: Non-volatile
Row Status: Active
------------------------------
Group Name: Initial
Read View: iso
Write View: iso
Notify View: iso
Storage Type: Non-volatile
Row Status: Active
------------------------------
Group Name: initial