Supermicro SSE-F3548S - 2.6 System Logging (Syslog)

Supermicro SSE-F3548S/SSE-F3548SR Configuration User’s Guide
53
2.5.6 MAC Aging
Dynamic MAC address table entries are addresses learned by the switch that age when not in use. The
MAC aging time can be configured by users.
Follow the steps below to configure MAC aging.
Step
Command
Description
Step 1
configure terminal
Enters the configuration mode
Step 2
mac-address-table aging-time <10-1000000
seconds>
Configure MAC Aging time in range 10-
1000000 seconds.
Step 3
End
Exits the configuration mode.
Step 4
show mac-address-table aging-time
Displays the MAC address table aging
time.
Step 5
write startup-config
Optional step – saves this configuration
to be part of startup configuration.
The “no mac-address-table aging-time” command resets MAC aging to its default value of
300 seconds.
The example below shows the commands used to configure MAC Aging.
SMIS# configure terminal
SMIS(config)# mac-address-table aging-time 50000
SMIS(config)# end
SMIS# show mac-address-table aging-time
Mac Address Aging Time: 50000
SMIS# show mac-address-table
Vlan Mac Address Type Ports
---- ----------- ---- -----
1 90:4c:e5:0b:04:77 Learnt Fx0/21
1 94:d7:23:94:88:d8 Learnt Fx0/21
Total Mac Addresses displayed: 2
2.6 System Logging (Syslog)
Supermicro switches send system message output to a klogging process called System Message Logging
(Syslog). Logging can be done at various locations:
• Console
• File
• Server