Supermicro SSE-F3548S - Page 52

Supermicro SSE-F3548S/SSE-F3548SR Configuration User’s Guide
52
which the received packet is
forwarded. Valid interfaces include
physical ports or port channels.
Interface-type - may be any of the
following:
fx-ethernet – fx
cx-ethernet – cx
interface-id is in slot/port format for all
physical interfaces.
Step 3
End
Exits the configuration mode.
Step 4
show mac-address-table static multicast [vlan
<vlan-range>] [address <aa:aa:aa
:aa:aa:aa>] [{interface <interface-type><interface-
id> }]
show mac-address-table static unicast [vlan <vlan-
range>] [address <aa:aa:aa:a
a:aa:aa>] [{interface <interface-type><interface-id>
}]
Displays the static MAC configuration.
Step 5
write startup-config
Optional step – saves this configuration
to be part of startup configuration.
The “ no mac-address-table static multicast <aa:aa:aa:aa:aa:aa> vlan <vlan-id(1-4069)>
[recv-port <interface-type><interface-id>]andno mac-address-table static unicast
<aa:aa:aa:aa:aa:aa> vlan <vlan-id(1-4069)> [recv-port <interface-type><interface-id>]”
command deletes the particular static MAC entry.
The “no mac-address-table static multicast <aa:aa:aa)> [recv-port <interface-
type><interface-id>]” command deletes the particular staticmulticast MAC entry.
The example below shows the commands used to configure a static MAC.
SMIS# configure terminal
SMIS(config)# mac-address-table static unicast 90:4e:e5:0c:03:75 vlan 1 interface fx 0/14 status permanent
SMIS(config)# end
SMIS# show mac-address-table static unicast
Vlan Mac Address Status Ports
---- ----------- ------ -----
1 90:4e:e5:0c:03:75 Permanent Fx0/14
Total Mac Addresses displayed: 1