357 |341
14.1.4 LLDPConfiguration
The example below shows the commands used to configure LLDP by connecting two switches: Switch A
and Switch B.
Figure LLDP-3: LLDP Configuration Example
Switch A
SMIS# configure terminal
SMIS(config)# set lldp enable
SMIS(config)# end
SMIS# show lldp
LLDP is enabled
Transmit Interval : 30
Holdtime Multiplier : 4
Reinitialization Delay : 2
Tx Delay : 2
Notification Interval : 5
Chassis Id SubType : Mac Address
Chassis Id : 00:30:48:e3:04:75
SMIS# show lldp neighbors
Capability Codes :
(R) Router, (B) Bridge, (T) Telephone, (C) DOCSIS Cable Device,
(W) WLAN Access Point, (P) Repeater, (S) Station, (O) Other
Fx 0/22
Fx 0/21
Switch A Switch B
To Next Page
Loading...
