Supermicro SSE-F3548S - Trap UDP Port

Supermicro SSE-F3548S/SSE-F3548SR Configuration User’s Guide
298
stored in NVRAM and available after
restart.
Step 3
end
Exits the configuration mode.
Step 4
show snmp notify
show snmp inform statistics
Displays the SNMP notification
information and Inform statistics.
Step 5
write startup-config
Optional step – saves this SNMP
configuration to be part of the startup
configuration.
The “no snmp notify <NotifyName>” command deletes the specified SNMP notification.
The example below shows the commands used to configure the SNMP notification.
SMIS# configure terminal
SMIS(config)# snmp notify PUBLIC tag tag1 type trap nonvolatile
SMIS(config)# end
SMIS# show snmpnotif
Notify Name: PUBLIC
Notify Tag: tag1
Notify Type: trap
Storage Type: Non-volatile
Row Status: Active
------------------------------
Notify Name: iss
Notify Tag: iss
Notify Type: trap
Storage Type: Volatile
Row Status: Active
------------------------------
Notify Name: iss1
Notify Tag: iss1
Notify Type: trap
Storage Type: Volatile
Row Status: Active
------------------------------
11.7.4 Trap UDP Port
The default UDP port for traps is 162. Supermicro switches providean option for users to change this trap
UDP port.