Supermicro SSE-F3548S - 6.7 Configuring RSTP

Supermicro SSE-F3548S/SSE-F3548SR Configuration User’s Guide
166
The examples below show various ways to configure MST region parameters.
Configure the MST region with name dc1_region, revision number 1 and map the VLANs 100 to 300 to
MST instance 10.
SMIS# configure terminal
SMIS(config)# spanning-tree mst configuration
SMIS(config-mst)# name dc1_region
SMIS(config-mst)# revision 1
SMIS(config-mst)# instance 10 vlan 100-300
SMIS(config-mst)# end
Remove the VLANs 201 to 250 from MST instance 10.
SMIS# configure terminal
SMIS(config)# spanning-tree mst configuration
SMIS(config-mst)# noinstance 10 vlan 201-250
SMIS(config-mst)# end
Delete the MST instance 10.
SMIS# configure terminal
SMIS(config)# spanning-tree mst configuration
SMIS(config-mst)# noinstance 10
SMIS(config-mst)# end
6.7 Configuring RSTP
Spanning tree is enabled by default in MST mode in Supermicro switches.
Follow the steps below to change to RSTP.
Step
Command
Description
Step 1
configure terminal
Enters the configuration mode
Step 2
spanning-tree mode rst
Configures the switch to operate in
RSTP mode.
Step 3
end
Exits the configuration mode.
Step 4
show spanning-tree
Displays the spanning tree mode
information.
Step 5
write startup-config
Optional step – saves this spanning tree
configuration to be part of startup