Supermicro SSE-F3548S - Page 165

Supermicro SSE-F3548S/SSE-F3548SR Configuration User’s Guide
165
• Instance to VLAN mapping
Follow the steps below to configure the MST region parameters.
Step
Command
Description
Step 1
configure terminal
Enters the configuration mode
Step 2
spanning-tree mst configuration
Enters the MST configuration mode
Step 3
instance<instance-id(1-16)>vlan<vlan-range>
Creates a MST instance and maps it to
the given VLAN range.
instance-id – The MST instance
identifier may be from 1 to 16.
vlan-range – may be any VLAN number
or list of VLAN numbers. Multiple VLAN
numbers can be provided as comma-
separated values. Consecutive VLAN
numbers can be provided as a range,
such as 5-10.
User can configure VLANs with
identifiers 1 to 4069.
Step 4
name<name-string>
Configures the MST region name.
name-string–Alphanumeric case
sensitive string with maximum length of
32 characters.
The default name is system MAC
address.
Step 5
revision<revision-number>
Configures the MST region revision
number.
revision-number – The MST revision
number may be from 0 to 65535.
The default revision-number is 0.
Step 6
end
Exits the configuration mode.
Step 7
show spanning-tree mst configuration
Displays the spanning tree
MSTconfiguration parameters.
Step 8
write startup-config
Optional step – saves this spanning tree
configuration to be part of startup
configuration.
The “no name” command removes the configured MST region name.
The “no revision” command resets the configured MST region revision number to its default
value of 0.