Supermicro SSE-F3548S - SNMP Notify

Supermicro SSE-F3548S/SSE-F3548SR Configuration User’s Guide
297
Security Name: None
Security Level: No Authenitcation, No Privacy
Storage Type: Volatile
Row Status: Active
------------------------------
Target Parameter Name: param4
Message Processing Model: v2c
Security Model: v2c
Security Name: user4
Security Level: No Authenitcation, No Privacy
Storage Type: Volatile
Row Status: Active
------------------------------
Target Parameter Name: test1
Message Processing Model: v2c
Security Model: v1
Security Name: None
Security Level: No Authenitcation, No Privacy
Storage Type: Volatile
Row Status: Active
------------------------------
11.7.3 SNMP Notify
Notify is used to specify the type of notifications to be sent to particular targets that are grouped under a
particular tag.
Follow the steps below to configure the SNMP Notification.
Step
Command
Description
Step 1
configure terminal
Enters the configuration mode
Step 2
snmp notify <NotifyName> tag <TagName> type
{Trap | Inform}[{volatile | nonvolatile}]
Configures the SNMP Notify
information.
NotifyName- Alphanumeric value with a
maximum of 40 characters.
TagName –Specifies a group of targets
identified by this name. Alphanumeric
value with a maximum of 255
characters.
Type – Notification can be Trap or
Inform.
Use volatileif the value need not be
stored in NVRAM.
Use nonvolatile if the value must be