Supermicro SSE-F3548S - Applying IP Acls to Interfaces; ACL Ingress Port Configuration

Supermicro SSE-F3548S/SSE-F3548SR Configuration User’s Guide
232
SMIS# configure terminal
SMIS(config)# no ip access-list standard 50
8.3.4 Applying IP ACLs to Interfaces
IP Standard and Extended ACLs are applied to all physical interfaces by default. If users prefer to apply any
IP Standard or Extended ACL only to certain ports, the steps below need to be followed.
8.3.5 ACL Ingress Port Configuration
User can associate an ACL with multiple ingress ports. Follow the steps below to add ingress port(s) to an
ACL.
Step
Command
Description
Step 1
configure terminal
Enters the configuration mode
Step 2
interface <interface-type><interface-id>
or
interface range <interface-type><interface-id> ….
Defines the port or port lists on which
this IP Standard / Extended ACL needs
to be applied
Step 3
ip access-group { <access-list-number (1-32768)>
| <access-list-name> in
Adds the IP Standard / Extended ACL to
this ingress port
access-list-number – the ACL number
that needs to be added
access-list-name – the name of the ACL
which needs to be added
Step 4
show access-lists
Displays the configured ACL rules to
make sure this port has added the
required ACL
Step 5
write startup-config
Optional step – Saves this ACL
configuration to be part of startup
configuration
The example below shows applying anIP Standard ACL rule 100 to ports fx 0/1 and fx 0/10.
SMIS# configure terminal
SMIS(config)# interface fx 0/1
SMIS(config-if)# ip access-group 100 in
SMIS(config-if)# exit
SMIS(config)# int fx 0/10
SMIS(config-if)# ip access-group 100 in
Removing anIPStandard / Extended ACL from a port
Step
Command
Description