Supermicro SSE-F3548S - Removing Port Channels

Supermicro SSE-F3548S/SSE-F3548SR Configuration User’s Guide
130
The example below shows the steps necessary to modify the member ports modes of a port channel
interface.
Modify the member ports’ modes to “active” for ports cx 0/2 and cx 0/3.
SMIS# configure terminal
SMIS(config)# int range cx 0/2-3
SMIS(config-if)# no channel-group
SMIS(config-if)# channel-group 10 mode active
SMIS(config-if)# exit
4.6.3 Removing Port Channels
Step
Command
Description
Step 1
configure terminal
Enters the configuration mode
Step 2
no interface port-channel <channel-group-
Removes the port channel interface.
number>
Or
channel-group-number – may be any
number from 1 to 65535.
no interface range port-channel <channel-group-
number> ….
To remove multiple port channel
interfaces, use the “no interface range
number>
information.
show etherchannel [[channel-group-number] {
detail | load-balance | port | por
t-channel | summary | protocol}]
Step 7
write startup-config
Optional step – saves this port channel
configuration to be part of startup
configuration.