Supermicro SSE-F3548S - 14.1.1 Enabling LLDP; 14.1.2 Configuring LLDP Parameters

348 |341
LLDP Status (interface level)
Transmit and receive
TLV
None
HoldtimeMultiplier
4
Message Transmit Interval
30
ReinitializationDelay
2
Transmit Delay
2
Trap Notification Interval
5
Chassis ID
Switch MAC address
Chasis ID Subtype
MAC address
Port ID Subtype
Interface name
System Capabilities
None
Notification
Disabled
Notification Type
Mis-configuration
14.1.1 EnablingLLDP
LLDP is disabled by default in Supermicro switches. Follow the steps below to enable LLDP.
Step
Command
Description
Step 1
configure terminal
Enters the configuration mode
Step 2
set lldpenable
Enables LLDP in the switch.
Step 3
End
Exits the configuration mode.
Step 4
show lldp
Displays the LLDP global configuration
details
The “set lldp disable” command disables LLDP in the switch.
14.1.2 Configuring LLDP Parameters
Once LLDP is enabled globally, it is enabled on all supported interfaces by default. Supermicro switches
provide a user configuration to place an interface in only send or only receive mode.
Other LLDP parameters that can be configured in Supermicro switches are Notification type, Chassis-ID
Sub-type and Port-ID Sub-type.
Step
Command
Description
Step 1
configure terminal
Enters the configuration mode
Step 2
interface <interface-type><interface-id>
or
interface range
<interface-type><interface-id> ….
(Optional) Enters the interface
configuration mode.