Supermicro SSE-F3548S - Other Configurations

Supermicro SSE-F3548S/SSE-F3548SR Configuration User’s Guide
157
Step
Command
Description
Step 1
configure terminal
Enters the configuration mode
Step 2
interface port-channel <channel-group-number>
Creates a port channel using “interface
port-channel” command.
channel-group-number – may be any
number from 1 to 65535.
Step 3
mlag enable
Configure MLAG link from switch to the
partner devices.
Step 4
end
Exits the configuration mode.
Step 5
show mlag interface
Displays the details of MLAG interface
between peers and partner devices.
The “mlag disable” command disables the MLAG link between the switch and the partner
device.
swA#configure terminal
swA(config)# interface port-channel 1
swA(config-if)# mlag enable
swA#end
swA# show mlag interface
MLAGId Local Status Peer Status
------ ------------ -----------
Po 1 UP UP
The “show interface port channel” command also shows the basic port channel details for MLAG port
channels.
5.4.6 Other Configurations
MLAG peer switches exchange only the dynamic learned specific information. The configurations across
peer switches are not exchanged. Hence, users need to make sure MLAG peer switches are configured
correctly. The following configurations have to be similar across MLAG peer switches for correct
functionality.
Requirements
Comments
VLAN configurations for MLAG interfaces
Spanning tree configurations for MLAG
interfaces
ACL configurations related to MLAG
interfaces