Supermicro SSE-F3548S/SSE-F3548SR Configuration User’s Guide
SMIS# configure terminal
SMIS(config)# login authentication radius
SMIS(config)# end
SMIS# show system information
Switch Name : SMIS
Switch Base MAC Address : 00:30:48:e3:70:bc
SNMP EngineID : 80.00.08.1c.04.46.53
System Contact : http://www.supermicro.com/support
System Location : Supermicro
Logging Option : Console Logging
Login Authentication Mode : RADIUS
Snoop Forward Mode : MAC based
Config Restore Status : Not Initiated
Config Restore Option : No restore
Config Restore Filename : iss.conf
Config Save IP Address : 0.0.0.0
Device Up Time : 0 days 0 hrs 15 mins 43 secs
Boot-up Flash Area : Normal
NTP Broadcast Mode : No
[NTP] ntp is disabled
Server Key Prefer
=============== ===== ======
Key # Key
======= ====================================
Time zone offset not set
13.2 RADIUS
A sequence of events occurs during RADIUS client-server communication at the time of user login.
• The username and password are encrypted by the client and sent to RADIUS server.
• The client receives a response from the RADIUS server:
o ACCEPT—User authentication is successful.
o REJECT—User authentication failed. User is prompted to re-enter username/password, or
access is denied.
o CHALLENGE—Additional data is requested from the user.
o CHALLENGE PASSWORD—User is prompted to select a new password.
Along with ACCEPT or REJECT packets, service options (Telnet, SSH, rlogin, or privileged EXEC services) and
connection parameters like user timeouts are sent by RADIUS server.
Defaults – RADIUS
To Next Page
Loading...
