Supermicro SSE-F3548S - Load Balancing

Supermicro SSE-F3548S/SSE-F3548SR Configuration User’s Guide
138
….
following:
fx-ethernet – fx
cx-ethernet – cx
The “no lacp wait-time” command resets the LACP wait time to the default value of “2”.
The example below shows the necessary steps to configure the LACP wait time.
Configure the LACP wait time as 0 for ports cx 0/1 and cx 0/2.
SMIS# configure terminal
SMIS(config)# interface range cx 0/1-2
SMIS(config-if)# lacp wait-time 0
SMIS(config-if)# exit
4.6.5 Load Balancing
Supermicro switches support load balancing on aggregated links.
Switches distribute outgoing traffic on all member ports that are in a bundle state. The distribution
decision to transmit a packet on any particular member port is decided by a hash algorithm. Supermicro
switches support the following hash algorithms:Source MAC Base
• Packets will be distributed across the member ports based on the source MAC address of the packet.
Step 4 Exits the configuration mode.
Step
5 show running-config Displays the configured port priority
show etherchannel
information.
Step
6 write startup-config Optional step – saves this LACP wait