Supermicro SSE-F3548S - Enable;Disable Syslog

Supermicro SSE-F3548S/SSE-F3548SR Configuration User’s Guide
54
•
Parameter
Default Value
Syslog status
Enabled
Logging buffer size
50 entries
Console logging
Enabled
File Logging
Disabled
Trap Logging
Critical
MAC Address table update Logging
Disabled
Facility
Local0
2.6.1 Enable/Disable Syslog
Syslog is enabled by default in Supermicro switches.
Follow the steps below to disableSyslog.
Step
Command
Description
Step 1
configure terminal
Enters the configuration mode
Step 2
logging disable
Disable Syslog.
Step 3
End
Exits the configuration mode.
Step 4
show logging
Displays the Syslog configuration.
Step 5
write startup-config
Optional step – saves this configuration
to be part of startup configuration.
The “logging enable” command enables the Syslog feature.
The example below shows the commands used to disable Syslog.
SMIS# configure terminal
SMIS(config)# logging disable
SMIS(config)# end
SMIS# show logging
System Log Information
----------------------
Syslog logging: disabled(Number of messages 0)
Console logging: disabled(Number of messages 0)
File logging: disabled(Number of messages 0)
Log File Name:
File Max Entries: 500
TimeStamp option: enabled