Supermicro SSE-F3548S - MAC Extended ACL Configuration

Supermicro SSE-F3548S/SSE-F3548SR Configuration User’s Guide
227
In Port List
The list of ports this ACL is applied to. If it is applied to all ports, this
will be ALL.
OutPort
The egress port configured for this ACL. If no egress port configured,
this will be ALL.
Filter Action
Configured ACL action rule – deny, permit or redirect
Status
Current status of the ACL. The status should normally be active. In the
case of configuration errors, the ACL status may be inactive.
The below example displays a MAC Extended ACL.
SMIS#show access-lists mac 100
Extended MAC Access List 100
-----------------------------
Filter Priority : 1
Protocol Type : 0
EncapType : 0
Vlan Id :
Destination MAC Address : 00:25:90:01:02:03
Source MAC Address : 00:00:00:00:00:00
In Port List : Fx0/2
Out Port : ALLFilter Action : Deny
Status : Active
8.2.8 MAC Extended ACL Configuration
This example describes the commands required to implement the following ACL requirements on the
network setup shown in Figure ACL-1.
ACL 1 – Deny all traffic going from Server A to the gateway.
ACL 2 – Redirect all vlan 20 traffic coming from the gateway to Server B.
Figure ACL-1: MAC Extended ACL Example 1