Supermicro SSE-F3548S - 11.9 SNMP Configuration Example

Supermicro SSE-F3548S/SSE-F3548SR Configuration User’s Guide
304
UnRegister PDU:0
Close PDU:0
Response PDU:0
Rx Statistics
Rx Packets:0
Get PDU:0
GetNext PDU:0
GetBulk PDU:0
TestSet PDU:0
Commit PDU:0
Cleanup PDU:0
Undo PDU:0
Dropped Packets:0
Parse Drop Errors:0
Open Fail Errors:0
Close PDU:0
Response PDU:0
11.9 SNMPConfigurationExample
Configure the following requirements on a switch acting as an SNMP agent as shown above in Figure
SNMP-2.
1) Creates SNMP users
a. Create an SNMP user ‘user1’ Specify the authentication and privacy protocol and the
authentication and privacy passwords.
b. Creates an SNMP user ‘user2’. Specify the authentication protocol and password.
2) Creates SNMP groups
a. Create groupcalled superusersand associateuser1 with this group.
b. Create groupcalled generalusers and associate user1 with this group.
3) Create views
a. Creates an SNMP view ‘full’which will allow access to everything from the specified Object
Identifier
b. Creates an SNMP view ‘restricted’which will allow access to everything from the specified
OID onwards, and also adds a restriction to anything on a particular sub-tree.
4) Create group access
a. Access for superusers- fullread/write and notify privilege to the ‘full’ view
Switch - SNMP Agent
PC – SNMP Manager
Figure SNMP-2 – SNMP Configuration Example