Supermicro SSE-F3548S - Link Aggregation Configuration Example

Supermicro SSE-F3548S/SSE-F3548SR Configuration User’s Guide
141
Step
Command
Description
Step 1
configure terminal
Enters the configuration mode.
Step 2
set port-channel disable
Disables the link aggregation feature.
Step 3
End
Exits the configuration mode.
Step 4
show etherchannel
Displays link aggregation feature status.
Step 5
write startup-config
Optional step – saves this configuration
to be part of startup configuration.
To enable the link aggregation feature, follow the steps below.
Step
Command
Description
Step 1
configure terminal
Enters the configuration mode.
Step 2
set port-channel enable
Enables the link aggregation feature.
Step 3
End
Exits the configuration mode.
Step 4
show etherchannel
Displays link aggregation feature status
Step 5
write startup-config
Optional step – saves this configuration
to be part of startup configuration.
4.6.6 Link Aggregation Configuration Example
Configure switch A as shown below in Figure LA-3.
1. Aggregate ports Cx 0/3 and Cx 0/4 with LACP mode. Also configure this aggregation as a trunk
interface with native VLAN 20.
2. Aggregate ports Cx 0/1 and Cx 0/2 with LACP mode. Configure this aggregation as an access port
on VLAN 10.