Supermicro SSE-F3548S - Configuring Startup Config File Name

Supermicro SSE-F3548S/SSE-F3548SR Configuration User’s Guide
65
[OK]
SMIS# show stored-config r1sw1.conf
vlan 1
ports fx 0/1-48 untagged
ports cx 0/1-4 untagged
exit
snmp view restricted 1 excluded nonvolatile
setip igmp enable
setip pim enable
ip pim component 1
exit
2.7.3 Configuring Startup Config File Name
Supermicro switches provide an option to select a file stored in flash memory as the startup configuration
file that gets loaded when the switch is powered on or restarted.
Follow the steps below to configure the startup configuration.
Step
Command
Description
Step 1
configure terminal
Enters the configuration mode
Step 2
set startup-config<filename>
Configure Startup-config file name.
filename – name of the configuration
file.
Step 3
End
Exits the configuration mode.
Step 4
show startup-config
Displays the configured startup
configuration file contents.
The example below shows the commands used to configure the switch startup configuration.
SMIS# configure terminal
SMIS(config)# set startup-config config2.conf
SMIS(config)# end
SMIS# show startup-config
vlan 1
ports fx 0/1-48 untagged
ports cx 0/1-4 untagged
exit
snmp view restricted 1 excluded nonvolatile
setip igmp enable