Supermicro SSE-F3548S - Switch Contact

Supermicro SSE-F3548S/SSE-F3548SR Configuration User’s Guide
46
=============== ===== ======
Key # Key
======= ====================================
Time zone offset not set
2.5.2 Switch Contact
Supermicro switches provide an option to configure the switch in charge of contact details, usually an
email ID.
Follow the steps below to configure the switch contact.
Step
Command
Description
Step 1
configure terminal
Enters the configuration mode
Step 2
system contact <string - to use more than one
word, provide the string within double quotes>
Configure Switch Contact.
String – Contact information entered as
a String of maximum length 256.
Step 3
End
Exits the configuration mode.
Step 4
show system information
Displays the System information
configuration.
Step 5
write startup-config
Optional step – saves this configuration
to be part of startup configuration.
The System Contact configuration is automatically stored as part of the startup-config file.
The example below shows the commands used to configure the switch contact.
SMIS# configure terminal
SMIS(config)# system contact "User1 at CA”
SMIS(config)# end
SMIS# show system information
Switch Name: SMIS
Switch Base MAC Address: 00:30:48:e3:70:bc
SNMP EngineID: 80.00.08.1c.04.46.53
System Contact: User1 at CA
System Location: Supermicro
Logging Option: Console Logging
Login Authentication Mode: Local
Snoop Forward Mode: MAC based
Config Restore Status: Not Initiated
Config Restore Option: No restore
Config Restore Filename: iss.conf