Supermicro SSE-F3548S - Time Zone

Supermicro SSE-F3548S/SSE-F3548SR Configuration User’s Guide
43
The example below shows the commands used to configure system clock.
SMIS# clock set 09:26:15 31 august 2013
Wed Aug 31 09:26:15 2013
SMIS# show clock
Wed Aug 31 09:26:20 2013
2.4.6 Time Zone
The system clock maintains time based on Universal Time Coordinated (UTC), also known as Greenwich
Mean Time (GMT). The local time zone can be specified as an offset from UTC.
Follow the below steps to configure the time zone.
Step
Command
Description
Step 1
configure terminal
Enters the configuration mode
Step 2
tz posix <std><offset>[<dst>]
Configure the time zone.
<std> - Standard time text e.g. PST
<offset> - Time zone offset in
[+|-]hh[:mm[:ss]] format. This is
the value needed to be added to local
time to get to UST. This value is positive
if the local time zone is in west of the
Prime Merdian, otherwise it is negative.
<dst> - Day light savings time text e.g.
PDT
Step 3
end
Exits the configuration mode.
Step 4
show system information
Displays the time zone configuration.
Step 5
write startup-config
Optional step – saves this configuration
to be part of startup configuration.
The example below shows the commands used to configure the time zone offset.
SMIS# configure terminal
SMIS(config)# tz posix PST8
SMIS(config)# end
SMIS# show system information
Switch Name: SMIS
Switch Base MAC Address: 00:30:48:e3:70:bc
SNMP EngineID: 80.00.08.1c.04.46.53
System Contact: http://www.supermicro.com/support