Supermicro SSE-F3548S - Traps

Supermicro SSE-F3548S/SSE-F3548SR Configuration User’s Guide
60
The example below shows the commands used to configure the Syslog facility.
SMIS# configure terminal
SMIS(config)#logging facility local5
SMIS(config)# end
SMIS# show logging
System Log Information
----------------------
Syslog logging: enabled(Number of messages 0)
Console logging: disabled(Number of messages 0)
File logging: disabled(Number of messages 0)
Log File Name:
File Max Entries: 500
TimeStamp option: enabled
Trap logging: Critical
Log server IP: None
Facility: local5
Buffered size: 50 Entries
LogBuffer: (0 Entries)
LogFile: (0 Entries)
2.6.7 Traps
Supermicro switches provide an option for specifying the type of traps that are to be logged.
Follow the steps below to configure logging traps.
Step
Command
Description
Step 1
configure terminal
Enters the configuration mode
Step 2
logging trap [{ <level (0-7)> | alerts | critical |
debugging | emergencies |errors |informational |
notification | warnings }]
Configure Logging Traps.
There are various levels of traps that
can be logged.
Level 0 – Emergencies
Used for logging messages that are
equivalent to a panic condition.
Level 1 –Alerts
Used for logging messages that require
immediate attention.
Level 2 – Critical
Used for logging critical errors.
Level 3 –Errors
Used for error messages.