Supermicro SSE-F3548S - 6.4 Enabling;Disabling Spanning Tree

Supermicro SSE-F3548S/SSE-F3548SR Configuration User’s Guide
162
6.4 Enabling/Disabling Spanning Tree
6.4.1 Enable/Disable Spanning Tree Globally
Spanning tree is enabled by default in Supermicro switches globally.
Follow the steps below to disable the spanning tree globally.
Step
Command
Description
Step 1
configure terminal
Enters the configuration mode
Step 2
no spanning-tree
Disables the spanning tree globally
Step 3
end
Exits the configuration mode.
Step 4
show spanning-tree
Displays the spanning tree information.
Step 5
write startup-config
Optional step – saves this spanning tree
configuration to be part of startup
configuration.
The “spanning-tree” command enables the spanning tree globally.
The examples below show ways to disable/enable the spanning tree function on Supermicro switches.
Disable the spanning tree.
SMIS# configure terminal
SMIS(config)# no spanning-tree
SMIS(config)# end
Enable the spanning tree.
SMIS# configure terminal
SMIS(config)# spanning-tree
SMIS(config)# end
6.4.2 Enable/Disable Spanning Tree on Ports
Spanning tree is enabled by default on all the ports and port channels in Supermicro switches.
Follow the steps below to disable spanning tree on ports.
Step
Command
Description