Supermicro SSE-F3548S - System Location

Supermicro SSE-F3548S/SSE-F3548SR Configuration User’s Guide
47
Config Save IP Address: 0.0.0.0
Device Up Time: 0 days 0 hrs 50 mins 51 secs
Boot-up Flash Area: Normal
NTP Broadcast Mode: No
[NTP] ntp is disabled
Server Key Prefer
=============== ===== ======
Key # Key
======= ====================================
Time zone offset not set
2.5.3 System Location
Supermicro switches provide option to configure the switch location details.
Follow the steps below to configure the system location.
Step
Command
Description
Step 1
configure terminal
Enters the configuration mode
Step 2
system location <location name>
Configure System Location.
location name –Location of the switch
specified as a string of maximum size
256.
Step 3
End
Exits the configuration mode.
Step 4
show system information
Displays the System Location
configuration.
Step 5
write startup-config
Optional step – saves this configuration
to be part of startup configuration.
The System Location configuration is automatically stored as part of the startup-config file.
The example below shows the commands used to configure the system location.
SMIS# configure terminal
SMIS(config)# system location "Santa Clara"
SMIS(config)# end
SMIS# show system information
Switch Name: SMIS
Switch Base MAC Address: 00:30:48:e3:70:bc
SNMP EngineID: 80.00.08.1c.04.46.53