Supermicro SSE-F3548S - Syslog Server

Supermicro SSE-F3548S/SSE-F3548SR Configuration User’s Guide
55
Trap logging: Critical
Log server IP: None
Facility: Default (local0)
Buffered size: 50 Entries
LogBuffer: (0 Entries)
LogFile(0 Entries)
2.6.2 Syslog Server
In Supermicro switches, Syslog messages can be re-directed to a Syslog server.
Follow the steps below to configure the Syslog server.
Step
Command
Description
Step 1
configure terminal
Enters the configuration mode
Step 2
logging <ip-address>
Configure Syslog Server.
ip-address –IP address of Syslog server
Step 3
End
Exits the configuration mode.
Step 4
show logging
Displays the Syslog configuration.
Step 5
write startup-config
Optional step – saves this configuration
to be part of startup configuration.
The “no logging <ip-address>” command deletes the Syslog server.
The example below shows the commands used to configure a Syslog server.
SMIS# configure terminal
SMIS(config)# logging 192.168.1.3
SMIS(config)# end
SMIS# show logging
System Log Information
----------------------
Syslog logging: enabled(Number of messages 0)
Console logging: disabled(Number of messages 0)
File logging: disabled(Number of messages 0)
Log File Name:
File Max Entries: 500
TimeStamp option: enabled
Trap logging: Critical
Log server IP: 192.168.1.3
Facility: Default (local0)