Supermicro SSE-F3548S - 6.23 Spanning Tree Configuration Examples

Supermicro SSE-F3548S/SSE-F3548SR Configuration User’s Guide
187
SMIS(config-if)# spanning-tree link-type point-to-point
SMIS(config-if)# end
6.23 Spanning Tree Configuration Examples
Configure the following requirements on the switches as shown below in FigureMSTP-Eg.1.
1. Configure two MST instances separately for VLANs 100 and 200.
2. Configure switch B as the root switch for the VLAN 100 instance.
3. Configure switch C as the root switch for the VLAN 200 instance.
4. Configure port fx 0/1-40 in all switches as port fast.
Figure MSTP-Eg.1Spanning Tree MSTP Configuration Example
Configurations on switch A
SMIS# configure terminal
# Create the VLANs 100 and 200
SMIS(config)# vlan 100,200
SMIS(config-vlan)# exit
# Create MST instance for vlan 100 and 200
SMIS(config)# spanning-tree mst configuration
SMIS(config-mst)# instance 1 vlan 100
SMIS(config-mst)# instance 2 vlan 200
Switch B
Switch A
Fx
Fx
Cx 0/2
Cx 0/1
Switch C