Supermicro SSE-F3548S - Boot-Up Options

Supermicro SSE-F3548S/SSE-F3548SR Configuration User’s Guide
68
SMIS# firmware upgrade tftp://100.100.100.1/SWITCH_FIRMWARE_1.0.15.bin normal
By default, the switch boots using the normal firmware image. To boot up using the fallback
firmware image, use the command “set boot-up {normal | fallback}”.
2.7.8 Boot-up Options
Supermicro switches support dual firmware images (“normal” and “fallback”). The switch boots up from the
normal firmware image by default. Users can configure the switch to boot from the fallback firmware image.
Follow the steps below to configure the switch boot-up firmware option.
Step
Command
Description
Step 1
configure terminal
Enters the configuration mode
Step 2
set boot-up {normal | fallback}
Configure Switch Boot-Up options.
Step 3
End
Exits the configuration mode.
Step 4
show system information
Displays the system information
configuration.
The boot-up configuration is automatically stored as part of the startup-config file.
The example below shows the commands used to configure the switch boot-up options.
SMIS# configure terminal
SMIS(config)# set boot-up fallback
SMIS(config)# end
SMIS# show system information
Switch Name: SMIS
Switch Base MAC Address: 00:30:48:e3:70:bc
SNMP EngineID: 80.00.08.1c.04.46.53
System Contact: http://www.supermicro.com/support
System Location: Supermicro
Logging Option: Console Logging
Login Authentication Mode: Local
Snoop Forward Mode: MAC based
Config Restore Status: Not Initiated
Config Restore Option: No restore
Config Restore Filename: iss.conf
ConfigSave IP Address: 0.0.0.0
Device Up Time: 0 days 0 hrs 0 mins 53 secs
Boot-up Flash Area: Fallback
NTP Broadcast Mode: No