Supermicro SSE-F3548S - Applying MAC Extended Acls to Interfaces; ACL Ingress Port Configuration

Supermicro SSE-F3548S/SSE-F3548SR Configuration User’s Guide
223
Step 2
no mac access-list extended { <access-list-
number> | <access-list-name> }
Deletes a MAC Extended ACL using no
mac-access-list extended command.
access-list-number – the ACL number
that needs to be deleted
access-list-name – the name of the ACL
that needs to be deleted
Step 3
show access-lists
Displays the configured ACL rules to
make sure the deleted ACL is removed
properly
Step 4
write startup-config
Optional step – Saves this ACL
configuration to be part of startup
configuration.
The example below shows how to remove a MAC Extended ACL.
SMIS# configure terminal
SMIS(config)# no mac access-list extended 50
8.2.4 Applying MAC Extended ACLs to Interfaces
MAC Extended ACLs are applied to all physical interfaces by default. If users prefer to apply any MAC
Extended ACL only to certain ports, the steps below need to be followed.
8.2.5 ACL Ingress Port Configuration
User can associate an ACL with multiple ingress ports. Follow the steps below to add ingress port(s) to an
ACL.
Step
Command
Description
Step 1
configure terminal
Enters the configuration mode
Step 2
Interface <interface-type><interface-
id>
or
interface range <interface-type><interface-id> ….
The port or port lists on which this
MAC Extended ACL needs to be
applied.
Step 3
mac access-group { <short (1-32768)> |
<string(32)>} in
Adds the MAC Extended ACL to this
port.
access-list-number – the ACL number
that needs to be added
access-list-name – the name of the
ACL that needs to be added
Step 4
show access-lists
Displays the configured ACL rules to
make sure this port is added to the
required ACL.
Step 5
write startup-config
Optional step – Saves this ACL
configuration to be part of startup
configuration.