Supermicro SSE-F3548S - 2.3 Interface Properties

Supermicro SSE-F3548S/SSE-F3548SR Configuration User’s Guide
22
Services allowed: HTTP
Ip Address: 200.200.200.10
Ip Mask: 255.255.255.255
Services allowed: TELNET
2.3 Interface Properties
Supermicro switches support various types of interfaces (physical interfaces, port channel interfaces). Each
interface has different characteristics, some of which are configurable.
Parameter
Default Value
MTU
1500 bytes
Speed
Fx ports FX 0/1 to 0/48 – 25 Gbps
Cx ports CX 0/1 to 0/6 – 100 Gbsps
Negotiation
Disabled
Storm-control
Disabled
Description
None
Duplex Operation
Full
Flow Control
Off
FEC Mode
Off
2.3.1 Description
Supermicro switches allow users to configure a description string to the interfaces. This description string
will be useful to identify the interfaces easily.
Follow the steps below to configure interface description string.
Step
Command
Description
Step 1
configure terminal
Enters the configuration mode
Step 2
interface <interface-type><interface-id>
or
interface range <interface-type><interface-id> ….
Enters the interface configuration
mode.
interface-type – may be any of the
following:
fx-ethernet – fx
cx-ethernet – cx
interface-id is in slot/port format for all
physical interfaces.
To configure multiple interfaces, use
the “interface range …” command. To
provide a range use a hyphen (-)
between the start and end interface
numbers. E.g.: int range fx 0/1-10