Supermicro SSE-F3548S - Link-State Trap

Supermicro SSE-F3548S/SSE-F3548SR Configuration User’s Guide
300
Step 5
write startup-config
Optional step – saves this SNMP
configuration to be part of the startup
configuration.
The “no snmp-server enable traps snmp authentication” command disables SNMP
authentication traps.
The example below shows the commands used to enable the SNMP authentication traps.
SMIS# configure terminal
SMIS(config)# snmp-server enable traps snmp authentication
SMIS# end
SMIS(config)# show snmp-server traps
SNMP Trap Listen Port is 162
Currently enabled traps:
------------------------
linkup,linkdown,
Login Authentication Traps ENABLED.
11.7.6 Link-State Trap
Link-state traps are enabled for all interfaces by default in Supermicro switches. Traps are generated
when an interface toggles its state from Up to down or vice-versa.
Follow the steps below to disable SNMP Link-state trap.
Step
Command
Description
Step 1
configure terminal
Enters the configuration mode
Step 2
interface <interface-type><interface-id>
or
interface range <interface-type><interface-id> ….
Enters the interface configuration
mode.
interface-type – may be any of the
following:
fx-ethernet – fx