Supermicro SSE-F3548S - 3.17.2 Configuration Example 2

Supermicro SSE-F3548S/SSE-F3548SR Configuration User’s Guide
116
The required configuration for this example is shown below. The uplink ports can be left with their default
configuration as unprotected ports. All the downlink 25Gig ports need to be configured as protected ports.
3.17.2 Configuration Example 2
The Fx ports 1 to 24 should be able to communicate among themselves and also should be able to
communicate with uplink ports Cx 0/1 and Cx 0/2.
The Fx ports 25 to 48 should be able to communicate among themselves and also should be able to
communicate with uplink ports Cx 0/1 and Cx 0/2.
The ports 1 to 24 should not be able to communicate with the ports 25 to 48 and vice versa.
The required configuration for this example is given below. The uplink ports can be left with the default
configuration as unprotected ports. The downlink ports 1 to 24 can be configured as one community
(group) and ports 25 to 48 can be configured as another community (group).
SMIS# configure term
SMIS(config)# interface range fx 0/1-48
SMIS(config-if)# switchport protected
SMIS(config-if)# exit
Cx 0/1 Cx 0/2
1 2 3 47 48