Supermicro SSE-F3548S - 11.6 Access Control

Supermicro SSE-F3548S/SSE-F3548SR Configuration User’s Guide
284
11.6 Access Control
There are various parameters that control access to the SNMP Agent.
• Engine ID
• Community String
• User
• Group
• Group Access
11.6.1 Engine Identifier
The SNMP Engine Identifieris a unique identifier for the SNMP agent in a switch. It is used with a hashing
function in the agent to generate keys for authentication and encryption. Hence after any change in
theEngine Identifier,the following must be re-configured:
• SNMPv3 authentication
• SNMPv3 encryption/privacy
• Community
Follow the steps below to configure the SNMP Engine Identifier.
Step
Command
Description
Step 1
configure terminal
Enters the configuration mode
Step 2
snmpengineid<EngineIdentifier>
Configures the SNMP Engine Identifier.
EngineIdentifier-Hexadecimal number,
with length between 5 and 32 octets.
Each octet should be separated by a
period.
Step 3
end
Exits the configuration mode.
Step 4
show snmpengineID
Displays the SNMP engine Identifier
information.
Step 5
write startup-config
Optional step – saves this SNMP
configuration to be part of the startup
configuration.
The example below shows the commands used to configure the SNMP Engine Identifier.
SMIS# configure terminal
SMIS(config)# snmpengineid 80.00.08.1c.44.44
SMIS(config)# end
SMIS# show snmpengineid
EngineId: 80.00.08.1c.44.44