Supermicro SSE-F3548S - 5.3 Default Configuration; 5.4 MLAG Configurations

Supermicro SSE-F3548S/SSE-F3548SR Configuration User’s Guide
153
5.3 Default Configuration
Parameter
Default Value
System ID
None
System priority
32768
Keep alive time
3 seconds
IPL interface
None
MLAG status
Disabled
5.4 MLAG Configurations
The mandatory configurations for an MLAG are:
1) System ID
2) Priority
3) IPL port channel interface
4) Enabling MLAG on port channel interfaces
The keep alive time configuration is optional.
5.4.1 MLAG System ID
The MLAG system ID is a text string configured as a unique MAC address. MLAG switches use this MLAG
system ID to identify their peers.
The MLAG system ID must be configured the same in both peer switches. If this condition is not met, the
peer connection will not be established. All the MLAG links (connected to different partner devices) in the
switch will use this globally configured MLAG system ID.
The LACP globally unique system identifier is formed by combining the MLAG system ID and the MLAG
system priority.
Follow the steps below to configure the MLAG System ID.
Step
Command
Description
Step 1
configure terminal
Enters the configuration mode
Step 2
mlag system-identifier <aa:aa:aa:aa:aa:aa>
Configure the system ID
<aa:aa:aa:aa:aa:aa> -
Specify any
unicast MAC address to be used as the
MLAG system ID
Step 3
end
Exits the configuration mode.
Step 4
show mlag detail
Displays the MLAG configuration details