Supermicro SSE-F3548S - 2 System Configuration; 2.1 Management IP

Supermicro SSE-F3548S/SSE-F3548SR Configuration User’s Guide
16
2 System Configuration
2.1 Management IP
The SSE-G3548S/R comes with DHCP IP settings for default IP management.
2.1.1 Static Management IP Address
The IP address command can be used to manually configure the management interface IP address.
Follow the steps below to manually configure the management interface IP address.
Step
Command
Description
Step 1
configure terminal
Enters the configuration mode
Step 2
ip address [<ip-address> | <ip-address>/prefix-
length] [<subnet-mask>]
Configure the management interface IP
address manually.
ip-address – A valid IPv4 Address.
ip-address/prefix-length - A valid IPv4
Address with a prefix length of 1-32.
subnet-mask – A valid IP subnet mask.
Step 3
end
Exits the configuration mode.
Step 4
show ip interface
Displays the management interface IP
configuration.
The manual IP address configuration is saved automatically as part of the start-up config.
The “no ip address” command resets the switch IP address to 0.0.0.0.
The example below shows the commands used to configure the management interface IP address
manually.
SMIS# configure terminal
SMIS(config)# ip address 192.168.1.10
SMIS(config)# end
2.1.2 DHCP
Supermicro switches can be configured to obtain the management IP address through DHCP protocol. In
this case, the switch acts as a DHCP client and obtains an IP address for any DHCP server on the LAN.
DHCP is the default management IP address mode.
Follow the steps below to obtain the management interface IP address dynamically from a DHCP server.